O4x64 POWER OUTPUT BOARDS
Suitable for any Tracker or Unit Pipe Organs
Or any industrial control machines
O_4X64 can be rackable ith several units via the parallel bus. (See picture at the left)
If the magnets have Darlingtons one can control 256 magnets.
With a Darlington plus a 1K resistor added, one can control 512 magnets per board. (Boards O8x64)
Return to organ boards
Return to home page
- Full
isolation from power cards and microelectronic components via the
CIPAR board.
- Can be directly controlled by any Parallel port or Serial interface or Serial MIDI link.
- PC or any microprocessor directly interfaced.
- 256 (4
x 64) power outputs
- 4
x 64 pins 41612 standard rack connectors
- Darlington
arrays on board : 200mA per output pin.
- Or
Darlingtons directly on the magnets for heavy duty magnets.
- Or Darlingtons or Darlington boards
- up to 7A
and 50V per each output. (via extra Darlingtons)
- Each 64 outputs can drive in parallel many registers.
- Entirely
controlled by the KI7_MIDI_USB or the KI6x8x8_MIDI_USB cards.
- Or
connected to the PC parallel port of any PC via the CIPAR board.
- 5V
supply power required for the cards connected to the CIPAR card.
- Can
be plugged on the 32 bits bus with 32 output boards
possibly.
- 32x4x32
power outputs up to 7A each output pin. (If extra Darlingtons)
- Convenient
for any heavy duty magnets, magnet valves, drawstops.
- Classic slider magnets can be controlled directly by my software, without any extra elctronic interface
- MIDI INTERFACE via KI7_MIDI_USB or KI6x8x8_MIDI_USB boards
NOMENCLATURE COMPONENTS :